Air filming

"Ural Movie Park" Studio offers air filming:

 

Hardware configuration (technical equipment):

• Carrier frame (textolite milled, carbon, nylon, 28mm pipe, dural);

• BC engines - T-Motor MN4010-9 (original) 4 or 8;

• Screws (pair) - 15 x 5 screws (2 sets);

• Flight controller - DJI NAZA V2 with GPS module;

• Engine controllers - RUSAEROLAB SL55A;

• A set of silicone wires 14,16,10,12,20,22 AWG;

• Three-wire wire for the regulators of the motors and connections between the periphery;

• Video camera of the course camera - AOWAY 1000w 5.8GHz;

• Video camera camera with suspension - AOWAY 1000w 5.8GHz;

• Suspension of stabilization Feiyu Tech Mini 3D for GOPRO 3/3 + / 4 cameras with control on 3 axes;

• GOPRO 3+ camera;

• It is possible to install light with battery power up to 1kg.

 

 
 
Technical characteristics of the carrier
1. Purpose:Periodical video shooting of the territory within a 2 km radius from the take-off place
2. Main technical requirements:
2.1. Machine type - multimotor
2.2. The flight range is not less than 2 km with a payload of 0.5 kg.
2.3. Flight time - not less than 10 min. With a payload of 1 kg (at a temperature of + 15 ° C)
2.4. The maximum flight altitude is not less than 300 m.
2.5. Wind resistance – wind speed no more than 10 m / s.
2.6. Dimensions in transport position - no more than 1 m.
2.7. Operating temperature range - from minus 12 to +40 deg.
2.8. Flight conditions - drizzling rain, light snow, without icing, daytime
2.9. The format of video transmission to the ground is analog PAL.
2.10. Transmission and reception of video signal in real time to a monitor with a resolution of 640'480 pixels.
2.11.  An autonomous return to the place of start-up if the radio control was lost.